The ST-Link LD1 should light up, and the USB drive “NODE_L476RG” is mounted on the desktop.
-500x500.jpg "st nucleo f401re wifi")
When the ST-Link cable is connected to the target application, continue as follows: Another option is to break off the ST-Link part (see white dotted line in the Nucleo board figure above). Using the RX/TX/RST/SWO lines between a remote target and the Nucleo board ST-Link interface requires desoldering the 0 Ω bridges on the underside of the Nucleo board (see figure below). Preparation and connection of the adapter cableĪn 8-pin adapter cable acts as an ST-Link cable and is required to connect the Nucleo board to the target: Signalĭebug connector, VDD is not needed and may result in reverse current, therefore leave it open Open CN2 jumpers (2 x, this enables ST-Link for remote application debugging).Short JP4 via jumper (enables RX/TX signals on CN3).Solder in JP4 pin header (not factory fitted).Open JP6 jumper (3.3 V power of the Nucleo MCU, to avoid MCU signals).Do the following to connect the Nucleo board to the target (see figure of Nucleo board below): Use a standard Nucleo board which includes an ST-Link interface. Preparation of Nucleo board for remote target connection Use the “STLinkUpgrade” utility for updating the Nucleo L4 ST-Link firmware.Ensure that the Nucleo ST-Link firmware version is V2J29M18 or higher (otherwise the STML433 MCU does not work correctly):.Recommended STM manuals: UM1724, User manual, STM32 Nucleo boards.“Tera Term” or similar can be used as a Virtual COM terminal. the Mbed “.bin” files) can be copied to the Nucleo USB drive, which the Nucleo board will then flash into the target.
#St nucleo f401re wifi serial#
The Nucleo board is connected via USB to a host (Mac, Windows, or Linux), the debugging and serial wires are connected to the target.
#St nucleo f401re wifi how to#
This document describes how to use a Nucleo STM32L476RG board to connect to a target STM MCU for firmware downloading, debugging and serial terminal connection. RadioShuttle Sketch Installation for LongRa.RadioShuttle Sketch Installation for Eagle.
0 kommentar(er)
